crwdns2933803:09crwdne2933803:0
crwdns2933797:0Simarpal Kalsicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Simarpal Kalsi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Place the replacement spring in the hole designated of it on the side of the extruder plastic assembly. |
|---|---|
| + | [* black] Place the M3 x 8mm screw attached to the arm on top of the hole on the top right corner of the assembly base plate . |
| + | [* black] Very carefully compress the spring and slide the spring over the little extruded piece of plastic on the extruder arm. |
| + | [* black] When the spring, extruder arm and the M3 x 8mm screw have been aligned use your Phillips #2 screw driver to tighten the M3 x 8mm screw. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0