crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Kyle Smithcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kyle Smith

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Mark the hole location
-[* black] Use a marker or pen to draw a dot where you'll be drilling the keyring hole.
- [* icon_note] Draw the dot as close to the edge of the grey battery compartment as possible. This will allow you to place the battery compartment door while the keyring is attached.
+[* black] Use a marker or pen to draw a dot where you want to drill the keyring hole.
+ [* icon_note] Draw the dot as close to the edge of the gray battery compartment as possible. This will allow you to reattach the battery compartment door while the keyring is attached.
[* icon_note] The potential drill locations are at the left (moving clockwise) end of each battery compartment clip hole.
[* icon_note] Alternatively, you can locate our recommended drill location by rotating the AirTag so that the CE marking is upright. Then, mark the drill location at roughly seven o'clock.