crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Gina Kittlesoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Gina Kittleson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Assembling the Sensor
[* red] Attach aluminum strut channels to the sontek sensor using strut channel nuts, washers, and 3/8" bolts
-[* icon_note] You only need one strut channel on the side of the sensor that must connect to the vertical strut channel. The other side was removed during deployment.
+[* icon_note] Strut channels are not necessary for deployment if you do not need extra stability in deployment.
[* violet] Feed the conduit over the sontek connection cable to protect it when in the river. It will not make a physical connection to the sensor
[* orange] Screw the water tight sontek connection cable into the connection port.
[* yellow] Screw the other end of the conduit into the base of the node box with the excess sontek wire pulled through.