crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Anchevauls Walkercrwdnd2933797:0crwdne2933797:0

crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Open the case
[* black] Flip the mouse over to gain access to the bottom.
-[* red] Using a scalpel, pick, or similar tool, peel away the slide pads on the bottom of the mouse in order to expose the three screws.
+[* red] Gently peel away the slide pads on the bottom of the mouse using a pick in order to expose the three screws.
[* black] Peel away as little of the pads as possible, in order to preserve the adhesive on their undersides.
-[* orange] Using a PH0 / Phillips #0 driver, remove the 3 screws shown in red.
+[* orange] Using a PH0 / Phillips #0 driver, remove the 3 screws circled in red.
[* black] Gently separate the two halves of the case. Light prying may be required.
-[* black] For PCB removal : remove 3 PH0 screws from PCB surface. The whole PCB can be taken out for inspection and repair after the screws are removed.
+[* black] For PCB removal : remove the 3 PH0 screws from PCB surface. The whole PCB can be taken out for inspection and repair after the screws are removed.