crwdns2933803:04crwdne2933803:0
crwdns2933797:0Kyle Smithcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kyle Smith
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Cut along the perimeter of the rear cover |
|---|---|
| + | [* black] Repeat the process of heating and cutting the adhesive along the three remaining sides of the rear cover. |
| + | [* icon_note] You can insert each new opening pick in the gaps created by the opening picks left in each corner. |
| + | [* black] As you proceed, leave an opening pick in each corner to prevent the adhesive from re-sealing. |
| + | [* icon_note] If the rear cover is still attached to the frame after cutting through all four sides, try slicing through the adhesive again with an opening pick. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0