crwdns2933803:07crwdne2933803:0
crwdns2933797:0Jordyn Cardonacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jordyn Cardona
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Place the circuit board into the the back of the car charger's case, make sure to align the light with its correct spot. It should be in the small, half-circle indent made for it. |
|---|---|
| + | [* orange] The negative connectors are going to over-extend their correct slots, once you have the latch aligned on top of the USB port, carefully push in the connectors and lay them into their correct slots. |
| + | [* icon_caution] DO NOT force the negative connectors down. This could break the plastic or the metal. |
| + | [* yellow] You may now place the top half of the car charger's case and close it tight. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0