crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:09crwdne2933803:0

crwdns2933797:0Christian Wendelcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Christian Wendel

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Replace the needle and reassemble the slide assembly.
-[* black] Insert the slide assembly back into the carburetor. Make sure the needle is lined up with the hole in the carburetor. Make sure that the diaphragm makes a good seal in the carburetor gasket groove.
+[* black] Replace the needle and reassemble the slide.
+[* black] Insert the slide assembly back into the carburetor. The needle is to be lined up with the hole in the carburetor. Make sure that the diaphragm makes a good seal in the carburetor gasket groove.
[* black] Insert the spring into the slide assembly and put the plastic housing back on. Maintain pressure while screwing four Phillips screws in the housing since it is spring loaded. Tighten in a diagonal pattern to ensure that the plastic housing is sealed properly.