crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Kyle Smithcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kyle Smith

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[title] Cut along the perimeter of the phone
-[* black] Repeat the previous heating and cutting procedure for the remaining three sides of the phone.
-[* black] Leave an opening pick in each corner as you continue to the next to prevent the adhesive from resealing.
-[* icon_note] The rear cover will begin to separate from the phone as you finish all sides of the phone.
- [* icon_note] If the rear cover doesn't fully separate from the phone, use an opening pick to try cutting through the adhesive again.
+[title] Cut along the perimeter of the rear cover
+[* black] Repeat the process of heating and cutting the adhesive along the three remaining sides of the rear cover.
+ [* icon_note] You can insert each new opening pick in the gaps created by the opening picks left in each corner.
+[* black] As you proceed, leave an opening pick in each corner to prevent the adhesive from re-sealing.
+[* icon_note] If the rear cover is still attached to the frame after cutting through all four sides, try slicing through the adhesive again with an opening pick.