crwdns2933803:023crwdne2933803:0
crwdns2933797:0Thomas Kirschbaumcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Thomas Kirschbaum
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Take the new gasket and look at it closely. There should be 2 rings of adhesive on it being covered up by blue strips of plastic. You will also notice there are 2 notches on thw inner portion of the gasket. This will help guide you with installing the new gasket | |
| [* black] Insert the home button perpendicular to the gasket making sure to have it go through the 2 inner notches of the gasket and having the blue adhesives strips towards the part of the button where your finger clicks. | |
| [* black] Once the gasket is on the home button, it is time to align it with the hole of the digitizer and to apply the gasket. | |
| [* icon_note] One notch of the inner part of the gasket will go where the flex cable meets the home button. | |
| [* icon_note] When you remove the in blue plastic, that adhesive is suppose to adhere to the home button. | |
| [* black] Remove the inner most blue plastic by using ESD safe tweezers and a sharp xacto knife. You will pull the blue plastic up, cut it with the xacto knife, and remove the blue plastic from the new gasket. | |
| - | [* black] Place the home button in the hole of the digitizer, and |
| + | [* black] Place the home button in the hole of the digitizer, and angle the flex cable towards the left of the digitizer (the side where the digitizer flex cables are). Make sure the gasket notch lines up with the flex cable and then press down on the gasket to adhere it to the home button. |
| [* black] Lift the home button back up and use a combination of ESD tweezers and an xacto knife to remove the outermost blue plastic. This plastic will adhere to the digitizer. Take the home button and put it in the hole the same way you did in the previous step. Once you are confident it is in the right position, firmly press down on the gasket. |