crwdns2933803:03crwdne2933803:0
crwdns2933797:0Thomas Kirschbaumcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Thomas Kirschbaum
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] After heating up the left side of the digitizer, take a suction cup and ***GENTLY*** press against the digitizer | |
| [* icon_note] This will create a small gap in-between the digitizer and the frame. | |
| [* icon_caution] Be careful not to push too hard or to crack the LCD screen | |
| [* black] Insert a halberd spudger into the small gap. Gently pull down on the spudger to slide it along the edge of the digitizer and frame | |
| [* yellow] If you can see the tip of the opening pick through the front glass, don't panic—just pull the pick out just a little bit. Most likely, everything will be fine, but try to avoid this as it may deposit adhesive on the front of the LCD that is difficult to clean off. | |
| [* icon_caution] With a cracked digitizer, this may be hard to do. You may need to crack the digitizer away from the adhesive. Be careful doing this as cracking the digitizer more can cause shards of glass to fling unexpectedly. | |
| - | [* icon_caution] When cracking the digitizer away from the adhesive, make sure |
| + | [* icon_caution] When cracking the digitizer away from the adhesive, make sure ***NOT*** to rip the home button flex cable or digitizer flex cables |
| [* icon_caution] When you are ready to remove the digitizer from the frame near the home button, make sure to drag the halberd spudger towards the RIGHT of the iPad. This will help avoid irreparable damage to the home button flex cable. |