crwdns2933803:03crwdne2933803:0
crwdns2933797:0Leo Maxwellcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Leo Maxwell
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Bypassing the speed control board |
|---|---|
| - | [* black] If , like me, you never use the speed control on the Jigsaw, you can remove it permanently. |
| + | [title] Optional Bypassing the speed control board |
| + | [* black] If , like me, you never use the speed control on the Jigsaw, you can remove it permanently, and bypass it. |
| [* black] To do so, you will need to cut the wires between the switch and the PCB, and the PCB and the motor. | |
| [* black] Then join the white wires together, and the black and blue wires together. The multipin connector is not required. | |
| [* black] I did this by soldering them together and covering the join in Heat-shrink tubing. | |
| [* black] It is recommended to add an X2 0.1μF 310V capacitor across the wires to prevent electrical noise and excessive sparking from the motor brushes, which would shorten the life of the motor, |