crwdns2933805:0crwdne2933805:0
crwdns2933797:0Leo Maxwellcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Leo Maxwell
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Optional- bypass control board. | |
| [* black] If , like me, you never use the speed control on the Jigsaw, you can remove it permanently. | |
| [* black] To do so, you will need to cut the wires between the switch and the PCB, and the PCB and the motor. | |
| - | [* black] |
| - | [* black] I did this by soldering them and covering the join in Heatshrink tubing. It is recommended to add an X2 0.1 |
| + | [* black] Then join the white wires together, and the black and blue wires together. The multipin connector is not required. |
| + | [* black] I did this by soldering them and covering the join in Heatshrink tubing. It is recommended to add an X2 0.1µF 310V capacitor across the wires to prevent electrical noise and excessive sparking from the motor brushes, which will shorten the life of the motor, |