crwdns2933803:01crwdne2933803:0
crwdns2933797:0Walter Galancrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Flip the Apple TV over so that the bottom of the unit is facing up. |
|---|---|
| - | [* black] You need to remove the rubber base to get access to the screws. |
| - | [* black] Starting at one side of the device, use a hairdryer or low temperature heat gun to soften the adhesive holding the rubber in place. |
| - | [* black] While the adhesive is still warm, pull up on the lip of the base to detach it from the metal plate. |
| - | [* black] Continue heating and pulling, slowly, until you have removed the entire pad. |
| - | [* black] Be careful, rubber can get ripped easily! |
| - | [* icon_caution] The pad will be hot; take care not to burn your fingers! |
| + | [* icon_reminder] Flip the Apple TV over so that the bottom of the unit is facing up. |
| + | [* icon_note] You need to remove the rubber base to get access to the screws. |
| + | [* black] Starting at one side of the device, use a hairdryer or a heat gun to soften the adhesive holding the rubber base in place. |
| + | [* icon_caution] The rubber base will be hot after heating, take extreme while proceeding. |
| + | [* black] While the adhesive is still warm, peel the bottom of the rubber base upwards to detach it from the metal plate. |
| + | [* black] Repeat the procedure described above until the rubber base has been completely removed. |