crwdns2933803:01crwdne2933803:0
crwdns2933797:0ekalfcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 ekalf
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] The battery configuration seems to be 4S2P, with custom 18650 Li-Ion cells. |
|---|---|
| + | [* black] Two circuit boards are on the USB plug end, with large inductors inbetween, that are stuck in place with white silicon(?) glue. |
| + | [* black] The heat conducting grey foam has some sort of black heat spreader under it, with the thermocouple attached to that - the heat spreader seems to go below the (heat isolating?) white sticky foam that is over the battery part. |
| + | [* black] I didn't risk disassembling my power bank any further as I still need it - there seem to be phillips screws holding down the circuit board though. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0