crwdns2933803:06crwdne2933803:0
crwdns2933797:0Shawn Menardcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Corbanizer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Repeat step 5 after turning the light switch for the light to the on position. |
|---|---|
| - | [* icon_caution] Be careful to only touch the wires with the multimeter leads ONLY as there should now be electricity at the wires. |
| - | [* red] The measured voltage should read between 110-125V. Turn the light switch off immediately after performing this step. |
| - | [* icon_note] If the measured voltage is not within the parameters, contact a qualified electrician for further service, otherwise, move on to step 7. |
| + | [* black] Switch room's circuit breaker to ***ON ***position. |
| + | [* black] Turn light switch on and repeat step 5. |
| + | [* icon_caution] ***Shock Hazard***. Electricity should now running through wires. Only touch wires with multimeter leads. |
| + | [* black] Make sure multimeter reads between 110-125 volts. |
| + | [* icon_note] If the measured voltage is not between 110-125 volts, do not continue. Contact a qualified electrician for further service. |
| + | [* black] Turn off light switch. |
| + | [* black] Change room's circuit breaker to ***OFF ***position. |