crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Robert Boydcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Robert Boyd

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Insert the flathead screwdriver into the hole between the x-clamp and the heat sink pin with the head parallel to the motherboard.
+[* black] With the head parallel to the motherboard, insert a flathead screwdriver from the side between the heat sink pin and the x-clamp hook.
[* black] Twist the flathead screwdriver clockwise to pry the bottom edge of the x-clamp out of the groove in the heat sink pin.
- [* icon_note] If twisting the 1.5 mm flathead screwdriver twists freely in the hole, try increasing the size of the bit.
- [* icon_note] The x-clamp should pop off the heat sink pin while you are twisting. If not, try repeating the previous step before attempting this one again.
+ [* icon_note] If you have trouble, try using a larger flathead screwdriver.
+ [* icon_note] As you twist, the x-clamp should pop off the heat sink pin. If not, try repeating the previous step before attempting this one again.