crwdns2933803:02crwdne2933803:0
crwdns2933797:0Robert Boydcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Robert Boyd
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Now that it is loose, insert a flathead where the head is parallel to the motherboard. |
|---|---|
| - | [* black] Now twist the flathead clockwise to pry the bottom edge of the clamp out of the groove in the pin. |
| - | [* black] Note: it should pop up just from twisting. |
| + | [* black] Insert the flathead screwdriver into the hole between the x-clamp and the heat sink pin with the head parallel to the motherboard. |
| + | [* black] Twist the flathead screwdriver clockwise to pry the bottom edge of the x-clamp out of the groove in the heat sink pin. |
| + | [* icon_note] If twisting the 1.5 mm flathead screwdriver twists freely in the hole, try increasing the size of the bit. |
| + | [* icon_note] The x-clamp should pop off the heat sink pin while you are twisting. If not, try repeating the previous step before attempting this one again. |