crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Robert Boydcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Robert Boyd

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Now that it is loose, insert a flathead where the head is parallel to the motherboard.
-[* black] Now twist the flathead clockwise to pry the bottom edge of the clamp out of the groove in the pin.
- [* black] Note: it should pop up just from twisting.
+[* black] Insert the flathead screwdriver into the hole between the x-clamp and the heat sink pin with the head parallel to the motherboard.
+[* black] Twist the flathead screwdriver clockwise to pry the bottom edge of the clamp out of the groove in the heat sink pin.
+ [* icon_note] The x-clamp should pop off the heat sink pin while you are twisting. If not, try repeating the previous step before attempting this one again.