crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Robert Boydcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Robert Boyd

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Loosen the two set screws on the middle flange bearing with a 1/8 inch hex key.
- [* icon_note] These set screws require a long hex key to loosen. These screws can be accessed from the front of the floor stripper or from the slots on the side of the frame.
+[* red] Use a 1/8 inch hex key to loosen the two set screws on the middle flange bearing.
+ [* icon_note] These set screws require either a long hex key or an extension to reach. They can be accessed from the front of the floor stripper or from the slots on either side of the frame.