crwdns2933803:05crwdne2933803:0
crwdns2933797:0Jamie Bellcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jamie Bell
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Lift the back end of the cover |
|---|---|
| + | [* icon_caution] The cover is connected to the body by a cable. Don't open the cover all the way until this cable is unplugged! |
| + | [* red] Unplug the 6-pin connector, then pry along the edges to release the plastic clips holding the top down |
| + | [* black] Remove the cover |
| + | [* icon_note] The clips at the nose of the drone require some extra pressure to release |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0