crwdns2933803:08crwdne2933803:0
crwdns2933797:0Olympia Mac Repaircrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Olympia Mac Repair
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Prepping the Video Control Board | |
| - | [* black] Cut a piece of scrap metal so it's large enough to overlap over the edges of the hole you cut in the previous step. |
| + | [* black] Cut a piece of scrap metal so it's large enough to overlap over the edges of the hole you cut in the previous step. ''(as a rule of thumb: the edges of the scrap metal should extend at least 25mm past each edge of your v''ideo control board) |
| [* black] Mount your Video Control Board to the scrap metal, using your choice of nuts+bolts or pop rivets. | |
| - | [* black] Protip: |
| + | [* black] Protip: Stick 2 layers of EVA sticky-backed craft foam onto the back of the circuit board prior to riveting the board to the metal. This prevents the board from shorting out against the metal. |