crwdns2933803:01crwdne2933803:0
crwdns2933797:0Zalmfiletcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Zalmfilet
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Getting Started | |
| [* icon_note] Make sure the on/off switch is set to off to prevent any accidental unwanted inputs to the machine | |
| [* black] Apply heat to the leftmost pad as shown in the image, near where the back of the palm rests while in use. | |
| - | [* black] Once heated, try to gently pry off the PTFE pad with a spudger or a guitar pick |
| - | [* black] Heat the adhesive again and try to pry it off in one piece so you can reuse it. |
| - | [* icon_note] In my case, the PTFE came off without the adhesive, if you manage to get it all off at once, even better. |
| + | [* black] Once heated, try to gently pry off the PTFE pad with a spudger or a guitar pick |
| + | [* black] Heat the adhesive again and try to pry it off in one piece so you can reuse it. |
| + | [* icon_note] In my case, the PTFE came off without the adhesive, if you manage to get it all off at once, even better. |
| [* black] Now, using your T5 Torx screwdriver, remove the 2 screws as marked in the image. |