crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Avionne Traylorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Avionne Traylor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Use a Phillips screwdriver to remove the two 2 screws that are located on the back of the control port.
+[* red] Use a Phillips screwdriver to remove the two screws on the back of the control port.
[* orange] Carefully separate the gray outer casing of the control port and the circuit board.