crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Kyle Smithcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kyle Smith

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Remove the rear cover
[* red] One side at a time, insert a pick next to the nosepiece, slide it to the edge and pry.
[* black] When both sides are loose, carefully lift the cover out.
[* icon_caution] The proximity sensor is still connected, so be careful to not rip the flex cable.
-[* black] Unlatch the small black clip which presses the cable against the contacts and then pull the flex cable out. It is lightly adhered to the headset.
-[* black] When reassembling make sure to position the cable correctly. Than latching the small black clip back on should be possible without the need of much force. If you don't connect the cable correctly the screen of the Quest 2 will stay black and the headset will turn of after a few seconds.
+[* black] Unlatch the small black clip and pull the flex cable out. It is lightly adhered to the headset.
+[* icon_reminder] During reassembly, make sure to position the cable correctly. Latching the small black clip back on shouldn't require much force. If you don't connect the cable correctly, the headset's screen may stay black and the device will turn off after a few seconds.