crwdns2933803:011crwdne2933803:0
crwdns2933797:0Martin Kuklinskicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Martin Kuklinski
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Open the four T20 Torx screws of the motors front cover |
|---|---|
| + | [* black] As you pull off the front cover, the shaft and rotor will most likely stay attached to the front cover, as the front bearing has a tighter fit than the rear one. You can do it this way, meaning you will need a little more force since you're also pulling out the brushes. This won't damage them, as they are held in place only by flatpin connectors. |
| + | [* black] Alternatively, use a hammer to gently knock on the drive shaft as you pull forward, so that the rotor stays in place. |