crwdns2933803:02crwdne2933803:0
crwdns2933797:0Cameron Smithcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Cameron Smith
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Start by placing your flathead screwdriver inside the microfiber towel. |
|---|---|
| + | [* black] Then, insert the covered flathead screwdriver in the vertical line space below the headlight. |
| + | [* black] Next, you are going to push the screwdriver into the crack while wiggling it side to side. By doing this action you will separate the trim under the headlight from the fender of the car. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0