crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Preparing / Disassembly 1a. | |
| [* icon_caution] After moving Z to 250mm above the bed and removing filament, Power Off, Power Cables UNPLUGGED! | |
| - | [* icon_note] Remove printhead cable and control box and set aside. |
| + | [* icon_note] Remove printhead, DB15 cable, and control box and set aside. |
| [* icon_reminder] You will need access to the back of the machine as well as the front. Give yourself enough room to rotate the machine if not work all they way around. ***Another tip*** is to place a piece of cardboard on the build surface to use a place to work. | |
| [* icon_note] If you have access to compressed air, blow the machine off. Use this time to clean the machine and give yourself good lighting to look over all the components thoroughly. | |
| [* yellow] Using a 8mm open end wrench, loosen the bottom inner wheel eccentric locknut. Back it off a few turns. | |
| [* green] Using a 7mm closed end wrench hold the nylock nut on the front of the X/Z bracket and loosen the eccentric wheel shaft with the M2.5 hex. | |
| [* orange] Fully remove both lower inner wheels. They will not be used. | |
| [* icon_note] 3 points is superior to 4 in this case. |