crwdns2933803:03crwdne2933803:0
crwdns2933797:0Brandon Adaircrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Brandon Adair
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove Main Board |
|---|---|
| + | [* black] Remove the four screws holding the mainpower board to the rear cover. |
| + | [* black] Starting at a corner use a spudger to gently pry up the main board. Work the spudger around the edges of the main board until it lifts easily. |
| + | [* black] Before completely removing the main board, lift up on the grey tape holding down the wires and pull it away from the back cover. |
| + | [* black] *Optional* You can also disconnect the wire harness if necessary, the process is the same as in Step 2. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0