crwdns2933803:07crwdne2933803:0
crwdns2933797:0Chris Mathecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Chris Mathe
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] 1) Connect the lighting, motor, and AC in wires to the replacement remote receiver. |
|---|---|
| + | [* black] 2) Gently tug each wire connection and make sure it's properly terminated with the twist on connectors. |
| + | [* black] 3) Cut a 5-6 inch piece of electrical tape and wrap around the end of each wire |
| + | [* black] TIP: Attach electrical tape at the base of the wires first, then finish wrapping tape around the twist connector. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0