crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:08crwdne2933803:0

crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Place the watch on a flat surface and make sure all the display adhesive is loose.
- [* icon_caution] If possible avoid working with the opening pick at the edge where the watch crown is located to prevent damaging the display cables. For the case you need to cut the adhesive on this edge don't insert the opening pick deeper than 1/16th of an inch (~2 mm).
-[* black] Slide an opening pick under opposite display edge of the watch crown.
-[* black] Tilt the opening pick to pry the display off the watch case.
+[* black] Place the watch on a flat surface and use an opening pick to slice through any remaining adhesive.
+ [* icon_caution] Try not to slice near the watch crown to prevent damaging the display cables. If you must slice near the crown, don't insert the opening pick deeper than 1/16th of an inch (~2 mm).
+[* black] Slide an opening pick under the opposite display edge of the watch crown.
+[* black] Twist the opening pick to loosen the display off the watch case.
[* icon_caution] Don't try to remove the display. It is still connected to the watch assembly.