crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Austin Blakelycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Austin Blakely

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Place your screen into the new shell and attach the two halves; the ribbon cable should slide through the gap like before.
-[* black] Put the top part of the case into place and clip it together. It may have a small gap between the shell, this happens with most aftermarket shells.
-[* black] Reinstall the speaker, buttons, and silicone pads.
+[* black] Place your screen into the new shell and affix the bezel into position; the ribbon cable should slide through the gap like before.
+[* icon_note] The case should click into place so that it stays together even without screws. There also may be a small gap between the top and bottom case, as this common on third party cases.
+[* black] Reinstall the speaker, buttons, and silicone pads into the bottom case.