crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Walter Galancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Walter Galan

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_note] You will be using an iOpener to transfer heat to the adhesive securing the home button assembly to the front glass panel assembly.
-[* black] Reheat the iOpener in the microwave for one minute on the highest power setting.
-[* black] Lay the iOpener flat on the front side, near the bottom edge of the front glass panel assembly, smoothing it out so that there is good contact between the surface of the front glass panel assembly and the iOpener.
-[* black] Let the bag sit on the front glass panel assembly for approximately 90 seconds before attempting to open the front panel.
+[* icon_note] The home button assembly is attached to the front panel with some adhesive. The use of an iOpener to soften the adhesive is highly recommended.
+[* black] Place the iOpener in the microwave and microwave it for ***one minute*** on the highest power setting.
+[* icon_caution] Be careful not to overheat the iOpener during the repair procedure. We recommend waiting at least two minutes before reheating the iOpener.
+[* black] Place the iOpener over the home button on the front edge of the display.