crwdns2933803:08crwdne2933803:0
crwdns2933797:0Matthew Prevattcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Matthew Prevatt
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Using a dry cotton swab remove any blockage in the fan channel that is preventing the fan from rotating. | |
| - | [* orange] If the fan bearing has unseated gently grip the fan housing as shown in the second image and pinch it until there is a tactile bump and the fan rotates freely. |
| + | [* orange] If the fan bearing has unseated, gently grip the fan housing as shown in the second image and pinch it until there is a tactile bump and the fan rotates freely. |
| [* icon_note] You can tell if your fan bearing is not seated properly if the channel is clear but the fan still resists rotation. | |
| [* black] If the stock adhesive has failed and the motor is no longer secured to the housing, apply pea sized amount of adhesive to a cotton swab and spread it evenly along the bottom of the motor. Repeat the pinching motion in the second image. | |
| [* icon_note] An adhesive that does not degrade under heat or expand is recommended. In my case I used Loctite Super Glue Gel. | |
| [* icon_reminder] Allow the adhesive to cure for the amount of time that the manufacturer suggests. |