crwdns2933423:0crwdne2933423:0

crwdns2933803:018crwdne2933803:0

crwdns2933797:0Peter Lamcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Peter Lam

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Place the charging port into the new shell.
-[* icon_note] Make sure the standoff on the shell fits into the hole on the charging port board.
-[* black] Screw the charging port into the shell.
+[* red] Align the standoff on the shell with the hole on the charging port board
+[* black] Screw the charging port into the shell with the 4.5mm Phillips #00 screw.
[* black] Gently move the tape back on the shell and over the screw.