crwdns2933803:02crwdne2933803:0
crwdns2933797:0Tarun Thirumacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tarun Thiruma
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Separate the bottom edge adhesive |
|---|---|
| + | [* black] Apply a suction cup to the back of the phone, as close to the center of the bottom edge as possible. |
| + | [* black] Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame. |
| + | [* black] Insert the point of an opening pick into the gap. |
| + | [* icon_note] Due to tight tolerances, this may take multiple attempts of reheating with the iOpener and separating with the suction cup before you get it right. |
| + | [* icon_caution] If you are having trouble creating a gap, your best bet is to apply more heat to the edge and try again. |
| + | [* black] Do not apply excessive force with the pick, or you will risk cracking the back cover glass. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0