crwdns2933803:011crwdne2933803:0
crwdns2933797:0Mister Fixercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove the back cover. | |
| - | [* icon_reminder] To install a back cover: |
| - | [* black] Use tweezers to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive. |
| - | [* black] Turn on your phone and test your repair before installing new adhesive and resealing the phone. |
| - | [* black] Carefully apply the new adhesive to the back cover, then line up one edge of the glass against the phone chassis and firmly press the glass into the phone. |
| - | [* icon_note] Alternatively, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold. |
| + | [* icon_reminder] To re-install the back cover: |
| + | [* black] Use tweezers to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive. You don't have to clear out adhesive down to the plastic but larger pieces should be removed. |
| + | [* black] Turn on your phone and test your repair before installing new adhesive and resealing the phone. This is where you will verify that you attached the new sensor correctly to the board. |
| + | [* black] Carefully apply the new adhesive to the back cover, then line up one edge of the glass against the phone chassis and firmly press the glass into the phone. This is not going to be easy so go slow, be patient. |