crwdns2933803:06crwdne2933803:0
crwdns2933797:0Jimcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jim
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_caution] Do not let the ***+*** and*** - ***battery tabs touch. | |
| + | [* icon_note] Red arrow is indicating the B+ pads and the Black arrow points to the B- pads. |
| [* black] Install the ring shaped orange paper insulator under the plus tab. | |
| [* black] Trim the minus nickle tab to length first. Hold the end of the tab away from the PLUS terminal and bend it. Bend the minus tab making a 90 degree above the PLUS terminal but leave enough room for the PCBA and insulators, maybe 3/16ths inch above the battery edge. | |
| [* black] Trim the plus nickle tab to length. Bend the plus tab now and leave enough room for the PCBA and insulators, maybe 3/16ths inch above the battery edge. | |
| [* black] Shape (cut) each nickle tab to make contact to the protection PCBA pads. The nickle material I used was wider than the original so I trimmed the edges to meet the pads. |