crwdns2933803:02crwdne2933803:0
crwdns2933797:0Carsten Frauenheimcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Carsten Frauenheim
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Wrap the adhesive pull tab around the middle of a spudger, spinning to secure. |
|---|---|
| + | [* black] Firmly pull up on the adhesive strip with constant force, spinning the spudger every so often to keep the exposed section of the pull tab as short as possible. |
| + | [* icon_note] This may take a lot of force. |
| + | [* icon_note] These adhesive pull tabs are very prone to snapping in half during this process. Try pulling as slowly as possible. |
| + | [* black] If the adhesive pull tabs are not stretching, you may need to reapply an iOpener. |
| + | [* black] Continue this process for each of the three pull tabs, until all are either out or snapped in half. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0