crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0True Hinescrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 True Hines

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_caution] Caution: Make sure to take care in prying case apart. There is a red wire that could get disconnected from the motherboard.
+[* icon_caution] Make sure to take care in prying case apart. There is a red wire that could get disconnected from the motherboard.
[* black] Gently seperate the two halves of the device, while taking care to not pull them too far apart, which could break the red wire that connects them.
-[* red] To remove the circuit board from the right section of the device, unscrew the two 0.5 cm phillips head screws using a Phillips #00 screwdriver.
-[* black] When the screws have been fully unscrewed, use the tweezers to carefully remove them from the device.
+[* red] To remove the circuit board from the right section of the device, unscrew the two 5.6 mm Phillips #00 screws.
+[* black] When the screws have been fully unscrewed, use the tweezers to remove them from the device.