crwdns2933803:09crwdne2933803:0
crwdns2933797:0bridgetttcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 bridgettt
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove any old solder by melting and slightly scraping it off. | |
| [* black] Insert the new heating element pin into the circuit board hole. Then push and flatten the heating pad. | |
| - | [* black] Next heat the pin to melt new solder to fuse pin and the board together. Repeat this step for the other side. |
| - | [* black] Once finished slide the circuit board chip back into the plastic housing. |
| + | [* black] Next, heat the pin to melt new solder to fuse the pin and the board together. Repeat this step for the other side. |
| + | [* black] Once finished, slide the circuit board chip back into the plastic housing of the heater. |