crwdns2936039:0CR10S Pro V1 MOSFET Upgradecrwdnd2936039:01crwdne2936039:0 - iFixit

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0Kul 4, 2024crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D

: crwdns2933769:0crwdne2933769:0
: crwdns2933771:0crwdne2933771:0
: crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

	[title] MOSFET Wiring and installation
	[* black] The used mounting holes are boxed in green
	[* black] The ++*red cable++ from the bed goes the ++Vout terminal++* boxed in red on the picture.
	[* black] The *++black cable++* from the bed is moved from the *++-V++* screw terminal of the Power supply unit(PSU) to the *+++V screw terminal++* on the PSU
	[* black] The *++red cable++* used to connect between the *++PSU +V++* and the SSR will now go to the screw terminal boxed in *++orange++*
-	[* black] ~~The~~ *++~~new~~ black cable++* ~~included in the kit~~ will connect between the *++ -V on the PSU++* and the *++V- on the MOSFET ++* box in Black.
-	[* black] ~~Then new 2 pin~~ connector cable will connect to the connector on the MOSFET boxed in blue and to the Control Board Bed positive and negative screw terminal for the bed heater
+	[* black] *++New black cable++* will connect between the *++ -V on the PSU++* and the *++V- on the MOSFET ++* box in Black.
+	[* black] *++New jst pigtail connector cable++* will connect to the connector on the MOSFET boxed in blue and to the Control Board Bed positive and negative screw terminal for the bed heater