crwdns2933803:08crwdne2933803:0
crwdns2933797:0Sigrowcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sigrow
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Final assembly |
|---|---|
| + | [* black] Insert the PCB so that the CO2 sensor is on the side of the Sigrow logo. |
| + | [* black] The PCB should be pressed against the PCB plate. |
| + | [* red] The antenna should now stick out less than 5 mm. |
| + | [* black] Slide the hat over the case. The hat should fit well and not come lose if you shake the senor hard. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0