crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0jamakcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Flip over the enclosure so that the circuit board is on the bottom and the optical sensor is on top.
-[* yellow] Remove the screw that downs the the optical sensor using a Torx T10 screwdriver.
- [* icon_note] Note: There is tape on the red and black wires that must be removed to separate the optical sensor.
+[* yellow] Remove the screw on the optical sensor using a Phillips #00 screwdriver.
+[* black] Remove the tape on the red and black wires that connect to the optical sensor. With the wires still attached, take the sensor off the ensclosure.
[* icon_caution] The wires on the optical sensor are very weak. They will break easily if excessive force is applied to them.
-[* red] Remove the four black screws on the edges of the case.
- [* icon_note] After taking out the screws, you don't have to open the case just yet.
+[* red] Remove the four black screws on the edges of the enclosure using a Phillips #00 screwdriver.
+ [* icon_note] After taking out the screws, you don't have to open the enclosure just yet.