crwdns2933803:06crwdne2933803:0
crwdns2933797:0Miriam Millercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Miriam Miller
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] FOLLOW THESE STEPS IF THERE IS NO SPEAKER PRESENT. |
|---|---|
| + | [* red] Use a flat head screwdriver to remove the rotating control knob from the encoder shaft |
| + | [* black] Locate the mounting threads on the outside of the encoder shaft. Use a 11 mm nut driver to remove all nuts and lock washers from these mounting holes. |
| + | [* black] Place the front enclosure on a flat surface, and orient the front to be facing down. Maintaining this position, remove the encoder shaft out of the mounting hole. |
| + | [* black] Flip the front enclosure and place it flat in front of you. Slide the interface board up vertically to remove it. |
| + | [* icon_reminder] When reassembling, orient the indent on the control knob to be 180 degrees from the flat part of the encoder shaft. Push the control knob into the encoder shaft. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0