crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Courtney Huittcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Courtney Huitt

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Remove the three connectors on the BCB. The valve connector which consists of two wires; the motor control board connector which consists of four wires, and the ground wire. Be sure to note the location and orientation of the connectors; label them is necessary. The ground wire is removed by removing the flat head screw and nylon washer.
+[* black] Move the end cap away from the unit. The wires to the power connector, voltage selector switch, elapsed time indicator, and DCp cable connector will limit the distance you can move the endcap.