crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Courtney Huittcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Courtney Huitt

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] With the torque screwdriver set to 6 in-lb, remove the six Philips head screws holding the rear end cap in place. Note that two of the six screws retain the cross bar.
+[* black] Cut the nylon ET-3 wire ties from the flow pick-up tubes at the BCB ports. Discard the wire ties. Label the tubes to ensure proper replacement, then remove them from the ports. Cut the nylon wire tie from the tube pressure transducer; discard the wire tie; and remove the pressure port tube.