crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Carsten Frauenheimcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Carsten Frauenheim

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_note] There are two wires coming out of each wire nut. Remove the wires that are connected to the main board assembly.
-[* black] Wedge a pick tool between the red wire and the wire nut casing to pry the wire loose.
- [* black] Pull the wire directly out of the wire nut to remove.
-[* black] Repeat this same process for the black wire and other wire nut.
+[* black] Insert the point of a pick tool into the push-in connector's inlet hole, which has the main board wire plugged into it.
+ [* black] With the pick tool still inserted, pull the red main board wire out of the push-in connector.
+ [* icon_note] Make sure you choose the inlet that connects to the main board, not the solenoid.
+[* black] Repeat this same process for the black wire and other push-in connector.