crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Carsten Frauenheimcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Carsten Frauenheim

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_note] There are two wires coming out of each wire nut. Remove the wires that are connected to the plastic routing on the main assembly.
-[* black] [guide|133998|Wedge a pick tool|stepid=265741] between the red wire and the wire nut casing to pry the wire loose.
- [* black] Pull the wire directly out of the wire nut to remove.
-[* black] Repeat this same process for the black wire and other wire nut.
+[* black] [guide|133998|Insert the point of a pick tool|stepid=265741] into the push-in connector's inlet hole, which has the solenoid wire plugged into it.
+[* black] With the pick tool still inserted, pull the red solenoid wire out of the push-in connector.
+ [* icon_note] Make sure you choose the inlet that connects to the solenoid, not the main board.
+[* black] Repeat this same process for the black wire and other push-in connector.
[* black] Fully remove both wires from the wire guide.