crwdns2933803:04crwdne2933803:0
crwdns2933797:0Allen Botnickcrwdnd2933797:0crwdne2933797:0
crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Reassembly | |
| - | [* black] |
| + | [* black] If you removed the wires put the microphone in the Hole shown by the Red arrow. The cable goes the path marked in orange. If you left the wires you don't have to do any of this. |
| [* black] Put the Ribbon Cable from the touch pad in again. Don't forget to push down the small black plastic bracket. | |
| - | [* black] Now you can just put the outer shell back on. Hold it in place and get the screws back in, from the other side |
| + | [* black] Put the outer shell back on but don't screw it in yet. Test the new battery before screwing the cover back on. It should power up normally provided the battery is good, you didn't damage anything and all the wires are connected. |
| + | [* black] Hold the shell in place and put the four screws back in, from the other side. |
| [* black] If you have removed the foam just put it back in. It holds perfectly without glue for me but if you want to be sure you could put a few drops in. | |
| [* black] The Earpads can just be pressed into place by hand. They only go in one direction so if you can't click all notches back in, try it the other way around. |