crwdns2933803:05crwdne2933803:0
crwdns2933797:0Luke Westcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Luke West
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] The insides were really covered with calcium carbonate (chalk) |
|---|---|
| + | [* black] I scrubbed out the inside of the unit, then I used an iron descaler product from a DIY store to remove the worst of the chalk |
| + | [* black] Donet submerge the top of the heater as it has electrical componnets on it |
| + | [* black] With the scale removed, the pitting to the die-cast heater body was clear. I polished this by using a very fine wet-or-dry paper placed on a flat surface . Dampen the wet-or-dry, and using small movements smooth the top half of the heater. See photo 2. |
| + | [* black] Clean the bottom half of the heater. You cant use the same technique as it has a central spiggot. |
| + | [* black] See photo 3 for the completed clean faces. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0